SprayMax 2K gloss clear coat
31,00 €
Two-component clear lacquer with very high resistance to chemicals, petrol and weathering.
Description
SprayMax 2K Clear Coat
2-component clear coat with very high chemical, petrol and weather resistance for high-quality, long-lasting sealing of repairs and new paintwork on cars and motorcycles.
Advantages
- Highest abrasion and scratch resistance
- Very smooth flow
- Long-lasting high gloss
- Very good polishability
- No colour deviation
- Excellent paint coverage
- Also suitable for higher ambient temperatures
- Particularly suitable for large areas
Item no.: (400 ml)
680 061 transparent
Technical information
Application:
- Touch-ups in the area of partial and repair paintwork
- Solvent- and water-dilutable base coat systems, dried according to manufacturer's instructions
- Old paintwork, cleaned and sanded
Pre-treatment:
- The substrate must be free of dust and grease. Shake the can thoroughly for 2 minutes before use. Test spray.
Activate 2K:
- Shake the can thoroughly for 2 minutes before triggering
- Remove the red push button from the cap.
- Turn the can 180° and place the push button on the pin in the bottom of the can.
- Place the can upside down with the cap on a firm surface.
- Press the red trigger button with the heel of your hand until it stops.
- After triggering, shake the can thoroughly again for 2 minutes.
Spraying:
- 1-2 coats
- Approx. 30μm per spray pass
- Flash-off time between spraying passes: 10-15 minutes, depending on temperature
Drying times:
- 12 hours at 20°C
- 35-40 minutes at 60°C
- IR drying recommended
Processing time:
- 48 hours at 20°C room temperature
- The processing time depends on the ambient temperature
- Higher temperatures result in a shorter pot life, lower temperatures in a longer pot life.
Gloss level:
- High gloss
Coverage:
- approx. 0.5 m² – 1 m² / spray can, depending on the thickness of the coat and the substrate
Notes:
- For professional use only
- Personal protective equipment must be worn (respiratory mask type: A2/P2 protective gloves, e.g. made of latex or nitrile)
- After finishing the painting process, turn the can upside down and spray the valve until empty.
- Dispose of the empty spray cans as recyclable material.
