SprayMax Plastic Adhesion Promoter

Application:

• Primer and adhesion promoter for all common exterior plastic parts on cars and lorries

Substrates:

• PP, PP/EPDM, ABS, SAN, PC, PA, PUR-RIM, RTPU, PPO, PBT, PUR soft foam, UP-GF plastics

Pre-treatment:

• Thoroughly clean the surface and lightly sand if necessary
• Damaged area must be free of grease and dust and dry
• Clean the substrate with SprayMax silicone remover.
• The substrate must be free of release agents;
• Tempering is recommended.
• Shake the can thoroughly for 2 minutes. Test spray.

Spray application:

• 1 light spray coat approx. 1-2μm

Drying times:

• Air drying 10 minutes / 20°C
• Can be painted over after 10 minutes / 20°C

Can be painted over:

• Can be painted over with all commercially available fillers and top coats, e.g. with SprayMax 1K acrylic filler, 2K thick-film filler, plastic colours, base coats, 2K top coats

Coverage:

• Approx. 0.5 m² – 1 m² / spray can, depending on layer thickness and substrate

Notes:

• For professional use only
• Personal protective equipment must be worn (respiratory mask type: A2/P2 protective gloves, e.g. made of latex or nitrile)
• After finishing the painting process, turn the can upside down and spray the valve until empty.
• Dispose of empty spray cans as recyclable waste.